Top 150+ Solved Embedded Real Time Operating System MCQ Questions Answer
Q. Which of following is not a valid bus in computer system ?
a. Data Bus
b. Memory Bus
c. Address Bus
d. System Bus
Q. The PCI follows a set of standards primarily used in _____ PC’s.
a. intel
b. motorola
c. sun
d. IBM
Q. The acronym HDI stands for:The acronym HDI stands for:
a. Half duplex interface
b. Hard disk
c. Hard disk interface
d. Help desk interference
Q. Bus which used to connect the monitor to the CPU is
a. PCI bus
b. SCSI bus
c. memory bus
d. rambus
Q. The device which starts data transfer is called __________
a. Master
b. Transactor
c. Distributor
d. Initiator
Q. The method which offers higher speeds of I/O transfers is ___________
a. Memory mapping
b. Interrupts
c. Program-controlled I/O
d. DMA
Q. What is the full form of ISA?
a. Industry Standard Architecture
b. International American Standard
c. International Standard Architecture
d. None of the mentioned
Q. The disadvantage of using a parallel mode of communication is ______
a. All of the mentioned
b. Leads to erroneous data transfer
c. Security of data
d. It is costly
Q. The transformation between the Parallel and serial ports is done with the help of ______
a. Flip flops
b. Logic circuits
c. Shift registers
d. None of the mentioned
Q. What WLAN device provides communications management services to wireless workstations?
a. Access Point
b. Antenna
c. Network Adaptor
d. Repeater
Q. RS-232, RS-449, RS-530, V-24, and X-21 are examples of?
a. standards for various types of transmission channels.
b. standards for interfaces between terminals and modems.
c. two methods of error detection and correction
d. standards for end-to-end performance of data communication systems.
Q. Many cables have “RS-232” connectors with some wires crossed or connected to each other because….
a. there are various RS-232 standards.
b. asynchronous modem reverses the direction of transmitted and received data from the standard.
c. accept commands from the terminals Via Rs-232 interface.
d. many computers and peripherals use RS-232 serial interfaces, but not as DTE-to-DCE