Top 550+ Solved Mass Transfer MCQ Questions Answer

From 406 to 420 of 589

Q. For stripping of a gas in a counter current stripper, the operating line

a. Lies above the equilibrium curve

b. Lies below the equilibrium curve

c. Can lie above or below the equilibrium curve

d. Is always parallel to the equilibrium curve

  • c. Can lie above or below the equilibrium curve

Q. The boiling points of pure components of a binary system __________ with increase in total pressure of the system.

a. Decreases

b. Increases

c. Remains unchanged

d. May increase or decrease, depends on the system

  • b. Increases

Q. Large scale usage of flash distillation is practised in

a. Soap manufacturing

b. Ammonia synthesis plant

c. Polymerisation industry

d. Petroleum refining

  • d. Petroleum refining

Q. Drying of a solid involves __________ transfer.

a. Only heat

b. Only mass

c. Both heat and mass

d. None of these

  • c. Both heat and mass

Q. Desulphurisation of petrol is done in a

a. Bollman extractor

b. Rotating disc extractor

c. Packed extraction column

d. Plate type extraction column

  • b. Rotating disc extractor

Q. Pick out the wrong statement

a. Co-current absorbers are usually used, when the gas to be dissolved in the liquid is a pure substance

b. In case of gas absorption, HETP is equal to HTU, when both the operating line & the equilibrium lines are parallel

c. Hatta number is important in case of gas absorption with chemical reaction

d. In actual practice, absorption is an endothermic process, while stripping is an exothermic process

  • d. In actual practice, absorption is an endothermic process, while stripping is an exothermic process

Q. Which of the following increases during evaporative cooling process with recirculated water supply?

a. Wet bulb temperature

b. Relative humidity

c. Partial pressure of vapour

d. Both (B) and (C)

  • d. Both (B) and (C)

Q. Operating velocity in a packed tower is usually __________ the flooding velocity.

a. Half

b. Twice

c. Equal to

d. More than

  • a. Half

Q. For gas absorption, low viscosity solvents are preferred, because of their

a. Better flow characteristics

b. Low pumping pressure drop

c. Rapid absorption rates

d. All (A), (B) and (C)

  • d. All (A), (B) and (C)

Q. Which of the following is used for the concentration of rubber latex?

a. Agitated film evaporator

b. Long tube vertical evaporator

c. Short tube evaporator

d. Calandria

  • a. Agitated film evaporator

Q. Pressure drop through plate tower as compared to that through packed tower, for the same duty will be

a. Less

b. More

c. Equal

d. Either (A) or (B); depends on the packing height

  • b. More

Q. Henry's law states that the

a. Partial pressure of a component over a solution is proportional to its mole fraction in the liquid

b. Partial pressure of a component over a solution is proportional to the mole fraction in the vapour

c. Vapour pressure is equal to the product of the mole fraction and total pressure

d. Partial pressure is equal to the product of the mole fraction and total pressure

  • a. Partial pressure of a component over a solution is proportional to its mole fraction in the liquid

Q. The change in enthalpy, when a unit quantity of gas is absorbed by relatively large quantity of adsorbent (on which a definite concentration of the adsorbed gas already exists) is termed as the

a. Differential heat of adsorption

b. Heat of wetting

c. Integral heat of adsorption

d. None of these

  • a. Differential heat of adsorption
Subscribe Now

Get All Updates & News