Top 50+ Solved Drawing Interpretation MCQ Questions Answer
Q. In welding symbol, if the symbol is above the baseline then the welding is to be done at
a. The arrow side
b. Other side of the arrow
c. Right side of the arrow
d. Both side of the arrow
Q. Where the welding symbol is placed when the welding is to be done at the arrow side
a. Below the baseline
b. Above the baseline
c. A & B both
d. None of them
Q. For the vertical position of the weld fillet and other symbols should saw in which side
a. Right
b. Left
c. Bottom
d. Above
Q. The full form of DFW is
a. Direct finish weld
b. Direct fusion welding
c. Diffusion welding
d. Double fusion Welding
Q. Full form of FB is Welding process is
a. Friction brazing
b. Furnace brazing
c. Function brazing
d. Finish brazing
Q. Full form of FRW in Welding process are
a. Friction Welding
b. Furnace Welding
c. Fusion Reaction welding
d. None of them
Q. Ground Connection equipment is used for ______ welding
a. Gas welding
b. Arc Welding
c. all
d. none
Q. In Edge preparation selection of joint is based on the following factors
a. Effect of warping
b. Cost of designing of the product
c. Characteristics of the product
d. All of them
Q. The gap between two plates to be joined with a view to obtain full penetration are
a. 1 to 3 mm
b. 3 to 5 mm
c. 5 to 8 mm
d. 5 to 10 mm
Q. For plates of thickness more than 16 mm which weld is used
a. Square butt weld
b. Single V butt weld
c. Double V butt Weld
d. Double U butt Weld
Q. For plates of thickness 3-5 mm which weld is used
a. Square butt weld
b. Single V butt weld
c. Double V butt Weld
d. Double U butt Weld
Q. The shape of slots made during edge preparation is based on
a. Joint design
b. Thickness of material
c. Joint strength required
d. All of the above
Q. For 0.5 to 15 mm thick plates are welded using
a. Single-V & Single-U edges
b. Double-V Edges
c. Double-V & Double-U edge
d. Square face edge
Q. In welding using Single-V and Single-U edge beveling angle is of
a. 15º to 30º
b. 30º to 60º
c. 60º to 80º
d. 5º to 15º