Top 250+ Solved Control of Electric Drives MCQ Questions Answer
Q. Among the following which one exhibits linearly rising load torque characteristics?
a. Elevators
b. Rolling Mills
c. Fan load
d. Separately excited dc generator connected to the resistive load
Q. What is the condition for the steady-state operation of the motor?
a. Load torque > Motor torque
b. Load torque <<<< Motor torque
c. Load torque = Motor torque
d. Load torque < Motor torque
Q. Choose the correct one. (* stands for multiplication, J represents the moment ofinertia, w represents angular spee(D).
a. J*d(w)/dt = Load torque – Motor torque
b. J*d(w)/dt = Load torque + Motor torque
c. J*d(w)/dt = Motor torque – Load torque
d. J*d(w)/dt = Load torque * Motor torque
Q. In DC chopper, the waveform for input and output voltages is respectively __________
a. Discontinuous and Continuous
b. Continuous and Discontinuous
c. Both continuous
d. Both discontinuous
Q. A chopper behaves as a __________
a. DC equivalent of AC switching device
b. DC equivalent of AC transformer
c. DC equivalent of AC relay
d. AC equivalent of circuit breaker
Q. A DC chopper feeds an RLE load. If the value of E is increased by 20%, the current ripple ________
a. increases by 20%
b. decreases by 20%
c. increases only 20%
d. remains the same
Q. The conduction loss versus device current characteristic of a power MOSFET isbest approximated by a ________
a. Straight line
b. Rectangular hyperbola
c. Parabola
d. Exponential decaying functions
Q. Which of the following device is NOT suitable for parallel operation?
a. MOSFET
b. BJT
c. IGBT
d. TRIAC
Q. Which of the following device should be used as a switch in a low power switched mode power supply (SMPS)?
a. GTO
b. BJT
c. MOSFET
d. TRIAC
Q. Servo motors are an example of which type of load?
a. Pulsating loads
b. Short time loads
c. Impact loads
d. Short time intermittent loads
Q. Load torque of the crane is independent of _________
a. Speed
b. Seebeck eect
c. Hall eect
d. Thomson eect
Q. The turn-o times of the devices in the increasing order is ___________I. MOSFET II. BJT III. IGBT IV. Thyristor
a. I, III, II, IV
b. I, II, III, IV
c. III, I, II, IV
d. III, II, IV, I
Q. Which of the following devices should be used as a switch for high power and highvoltage application?
a. GTO
b. MOSFET
c. TRIAC
d. Thyristor